Welcome To NetKnots.Com | The Most Trusted Knots On The Net.

Water Knot

How to tie the Water Knot or Ring Bend. The best knot to use when tying knots in webbing. Can be used to make slings and grab handles. Climbers most commonly use the Water Knot, also known as the Ring Bend, for tying webbing into loops. Make sure the tails exit from different sides of the knot and they should be at least three inches long to be able to be inspected for any slippage of the knot.

The Square Knot is one of 23 essential rope knots included on the waterproof Pro-Knot Outdoor Knot Cards - click to see.

Scroll to see Animated Water Knot below the illustration and tying instructions.

Water Knot Tying Instructions

  • Tie an overhand knot in one end of the webbing leaving the desired length of the loop free.

  • Retrace the knot in the opposite direction with the other end of the webbing and.

  • Pull tight. Make sure the free ends are a couple inches long to visually inspect for slippage during use.
Swiffy Output

Disclaimer: Any activity involving rope can be dangerous and may even be life threatening! Knot illustrations contained in this web site are not intended for rock climbing instruction. Many knots are not suitable for the risks involved in climbing. Where failure could cause property damage, injury, or death, seek professional instruction prior to use. Many factors affect knots including: the appropriateness of knots and rope materials used in particular applications, the age, size, and condition of ropes; and the accuracy with which these descriptions have been followed. No responsibility is accepted for incidents arising from the use of this content.